Originally Posted by
Eazy
I did swap to a new sensor wire but it did not help. The thing is this problem is intermittent, it starts fine then in the middle of a run i don't get the boost anymore as though it went to blinky I have to go to a full stop or even on n off again then it works again.
I had a similar problem with a LRP X12 motor. It ran fine at my workbench, but on the track after some laps it would send the esc into "error blinky mode" as i call it (both leds blinking). In the end it turned out to be a faulty sensor board in the motor causing this.
Christian