Hi :-)
A friend of mine made too me. I have used ALOT of time trying to find out were to buy one. No luck..
Finding the best material for the tool was not so easy for me here in Norway, but my friend found it for me.
Do you use lapping on your engines or do you just do running in noramlly?
Anders
I have been lapping engines for many years now...I mainly only lap over tight engines and do tradition breakin for most engines.... And usually when I lap I only bring the engines to a normal fitment then do a traditional breakin from that point......However from time to time special circumstances come up where we do complete lapped engines, where they go from the bench straight to the track..... There are pro's and cons to all the different methods.......Usually for my own personal engines I lap the engines to 75% , then run a couple of short tanks on the breakin bench, then its on the ground and ready to race...