R/C Tech Forums - View Single Post - Team Associated B4.2 Thread
Thread: Team Associated B4.2 Thread
View Single Post
Old 03-04-2013 | 07:22 AM
  #2357  
Wildcat1971's Avatar
Wildcat1971
Tech Prophet
iTrader: (84)
 
Joined: Apr 2012
Posts: 17,389
From: Arizona
Default
Originally Posted by Bob Barry
wireless receivers...... that's how I roll

http://www.amainhobbies.com/product_...Micro-Receiver

That's the one I use with my 4PL
Yeah, I kinda hope that becomes the norm. I have never liked antennas, lol.


Originally Posted by Matt Trimmings
use a small piston drill and put a hole about a 1/2 inch from the bottom of the antenna tube. feed the wire through that hole into the tube instead of going into the chassis.
Yeah, I did that last night, but I used my 4-40 bit I use before tapping. Then used an exacto to clean it up. I will probably stick with that for now. I had a few issues getting antenna to feed upwards, but i curled the tip and fed it in. worked much better. I was just debating going a step further and slotting it.
Wildcat1971 is offline  
Reply