Just flashed to 0.6.1 and now the I have some glitching on channel one (steering). Once in a while the steering servo will move then return to center when there is no steering input (even set the radio down and it happened while the radio was sitting on a table). Never had glitching issues with stock firmware.

Trouble shooting steps taken:
Rebound the Rx and TX
Changed the number of channels from 3 to 2
Recalibrated the Tx
New Battries
Changed Servo
Added/Removed Glitch Buster
Changed to 0.5.0_3Channel and no glitching after an hour with the TX sitting on a table

Would appericate any trouble shooting tips.