R/C Tech Forums - View Single Post - SC10 Thread Part 2
Thread: SC10 Thread Part 2
View Single Post
Old 12-09-2012 | 02:26 PM
  #1997  
ca3l
Tech Apprentice
iTrader: (1)
 
Joined: Nov 2012
Posts: 88
Default
Originally Posted by tom_chang79
RPM front arms requires RC10gt hinge pin. I don't remember the part number, but it stated on RPM's website... I just RPMed out my truck so I had to do the same... Also with RPM's front arms, you have to use their bulkhead, which are included...
Thanks for the response, but I think you guys are missing the question - my problem isn't with the hinge pin - I have that taken care of. My problem is with the screw. I don't have the original screw (that hold the hinge pins in place) and I need to know the right size of the screw.
Thanks guys!
ca3l is offline  
Reply