Originally Posted by
JoeyE
So right now my Rev Pro out of the box cannot run 4T motors?
...because there is no software for it?
You should have no problem running a 4.5T motor with your Revention Pro.
Originally Posted by
Ritchie T
Quick question, can i run the +40 sensor board with a 13.5 MMM ?
Thanks
Yes. Whatever the class you are running just keep an eye on your motor temperature.
Originally Posted by
atmeearacing
got the gt 2.0.bad switch from the box.1 month+ finally used switch from cirtix(support here in ill. so good)wired it in now switch doesnt work at all and powers up only when i hold the setup button down.any ideas
Just to clarify.
You are saying the switch that was included with your GT 2.0 was bad when it was new? Then you installed a on/off switch you took from a Cirtix you had onto the GT 2.0?