R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-07-2012 | 06:46 PM
  #21739  
rigor's Avatar
rigor
Tech Master
iTrader: (44)
 
Joined: Mar 2012
Posts: 1,610
From: Orange County, CA
Default
Originally Posted by OptimumRC
One thing to double check is what ball studs you are running on the hubs, make sure it is a short neck ball stud. Another thing is your hub spacing I always run hubs center, and the link is just about touching the rear springs, but that is only with the A hubs. With the C towers the link does not touch at all.
I am running the B hubs. Even the B4.1 FT manual online shows the rear hub ballstuds as "long". No where in the Big Bore shock instructions provided does it mention needing to use short ballstuds on the rear, or change ballstud mounting position.

Pic attached.
Attached Thumbnails Click image for larger version Name: IMAG0848.jpg Views: 314 Size: 149.0 KB ID: 978581  
rigor is offline  
Reply