Originally Posted by
kyle3333
When doing the 8mm mod, do you install the C hubs up side down? What ball stud do you need? Also, where are guys putting the 2.25 oz. up front?
Thanks!
Yes install the carbon hub upside down, you need the 12mm ballstuds. Same thing just longer than the stock ones.
Originally Posted by
CptKaos
FYI, if installing the FT saddle pack on an Exotek chassis move the holes 2mm towards the rear, the exo chassis has a thicker front bulkhead.
When using the front springs on the rear do you stretch them any to get some adj range on the shock body?
Larry
No do not stretch the springs, that will change their spring rate!