Originally Posted by
jpure009
With sway bars on the Rear, should both arms fall with no springs on??
Meaning: when i raise them, fall/drop independently from the other w/ no springs on?
I changed the hinge pins(were not bent), but didn't change the Rear A-Arms, because they looked fine.(Probably ran 12packs with them)
The front A-arms do fall w/out springs on(Sway bars on front), so I figured the Rear are suppose to also, I just don't remember. I just wanted to make sure, because, then I guess, I have to go back & change the rear a-arms.?.
THX
It could also be that you are using the wrong clips that hold the sway bar in position. There are 2 different clips with a total of 4 different sizes of holes that hold the sway bars. If you are using a set that is smaller than your bar, the bar will bind and the hubs/arms will not have free movement.