Originally Posted by
madweazl
Having a bit of an issue trying to get full wheel travel left to right from the steering servo. I have EPAs set to 150% which provides plenty to the right but not enough to the left. Ended up moving the horn one tooth to the left and that almost did the trick but after readjusting the subtrim, I'm still a smidge off. Outside of cutting the ball cups a bit shorter to bring the rack over manually, I'm about out of ideas. Any suggestions?
Had this same issue, if your looking at your car with the rear closest to you, look at your top deck you have those three screws, look at the left screw now turn your wheels to the left and look where the bellcrank touches
down in their you need to dremel just a little then can get full lock or use a sharp xacto knife. Should not have to take anything apart because its not very much u need to file away. Just a little on the left bellcrank and a little part of the chassis where that left screw goes into.