Originally Posted by
porkchop
the cars smooth turns on dime and it just works ever time i pass the remote it only hours be4 there ordering one on there smart phone at the track.
the boot is good to have just push it in it be fine. the case it self holds the ring.
I know I'm bringing this quote back from the grave. But it's not true. The case doesn't hold the ring for the front / rear center CVD. It's only the boot. If you don't use the ring at all the bearing covers the pin hole about 25%. I think it might be enough to not use the ring or boot. But i'm a little scared not too.
Since the boots seem to be a absolute must to hold the ring. Does everyone have them last long enough? Anyone try the cheaper Mugen boots?
http://www.amainhobbies.com/product_...-Joint-Boots-2
Another surprise while building it was I couldn't believe the rear chassis brace is connected to a plastic battery box
