Originally Posted by ChrisAttebery

Craig,

Your bodies look great. Nice job!

I got my bodies last night. I trimmed one out to fit my SC-R and got the first color painted last night. I like how it fits. Overall it is a little wider than the PL Flow-Tek and JC Raptor.

I have a question though. How are you cutting out the vents over the front fenders? When I did this on my Flow-Tek I tried using a body reamer to put a hole at each end and then cut with an X-acto knife between the holes. That was a PITB. Then I tried using a Dremel with a carbide ball nose cutter. That was easier, but wasn't as consistent.

Thanks,

Chris