Originally Posted by
i1justin
8 seems a bit high, but that is for an inside hole on the arm setup so you may be in the outside hole?
And those are just refs, use your ride height readings as the reading, but it should be to flat part of chassis without the undertray to make that measurement
Yep, double checked everything. Its on the inside hole. I just refilled my shocks again. I have managed to get it at 20mm rear ride hight using a 4mm spacing on the shock collar. Is 4mm reasonable compared to the 1.7mm stated? (I agree 8mm was a bit excessive before).
Im measuring ride height with the batteries in the car, no under tray and after dropping the car from about 25cm up.
I dont actually have a ride height measuing tool, im using my digital calipers as best i can.
SS