Originally Posted by
Odin544
Just bought a B4.1 and was curious about the hex conversion. Tried searching through the thread, but it comes up with a lot of non relevant posts.
Parts I'll need are:
sc10rs steering blocks
b4.1 hex front axle
clamp on hex front and rear
22 rear wheels and RB5 front wheels.
Is this correct? How about the bearings in the front? Does it use the same bearings as before? And is there a crush tube in there?
Sorry for the repeat of this question for the one thousandth time I'm sure.
No crush tube is used, due to the C clip used as the bearing stop
Items to do the hex conversion:
ASC9880 - Team Associated Hex Steering Block Set
ASC9881 - Team Associated Hex Front Axle Set
ASC3977 - 3/16 x 3/8 normal wheel bearings (4 pcs)
ASC6943 - 8/32 wheel nuts (I like the JCI2076 or JCI2075)
12mm hex adapters
PRO6077-00 and PRO6076-00 or JCI2081 and JCI2091 or ASC7497 (plastic)
Hex front wheels
PRO2735-02, PRO2734-04 or ASC9690, ASC9691
Hex rear wheels
PRO2736-02, PRO2736-04 or TLR7100, TLR7101
I didnt list JConcepts wheels as they are not current in stock at Amain and I haven't personally messed with the Kyosho wheels... but they should fit.