R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: JamesHealey
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Onroad Nitro Engine Zone
10-23-2016, 08:31 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

Agreed with Roelof the 9CL-WC is based on the 7...

Agreed with Roelof the 9CL-WC is based on the 7 port Nova crankcase and 14mm crankshaft, but with the case modified to accept a 9 port sleeve.

Same principal is adopted on Tesla, Max and Top...
Forum: Nitro On-Road
06-20-2016, 04:04 AM
Replies: 1,293
Views: 367,129
Posted By JamesHealey

My 977 Evo came with the new split mount for the...

My 977 Evo came with the new split mount for the Otto engines, but I run Novarossi engines anyway, so wasn't needed.
Forum: Onroad Nitro Engine Zone
05-28-2016, 09:36 AM
Replies: 49
Views: 15,590
Posted By JamesHealey

Do you have a standard Mito 35WC (onroad) not for...

Do you have a standard Mito 35WC (onroad) not for GT, dyno results?
Forum: Onroad Nitro Engine Zone
05-13-2016, 03:55 AM
Replies: 6,142
Views: 1,142,094
Posted By JamesHealey

Well I don't race above 40c or below 10c, so the...

Well I don't race above 40c or below 10c, so the 8 covers all fine, never encountered an issue.
Forum: Onroad Nitro Engine Zone
05-10-2016, 12:18 AM
Replies: 6,142
Views: 1,142,094
Posted By JamesHealey

C8TGH - for ambient temperature: 10°C/40°C ...

C8TGH - for ambient temperature: 10°C/40°C

This is the best plug to use with Novarossi engines, the plug included in the engine is best used for break in purposes.
Forum: Nitro On-Road
04-22-2016, 03:49 AM
Replies: 1,293
Views: 367,129
Posted By JamesHealey

Does the same on my Shepherd with Matrix Carbon...

Does the same on my Shepherd with Matrix Carbon rims, just force the lever over the plastic, it'll go.
Forum: Nitro On-Road
04-22-2016, 03:46 AM
Replies: 3
Views: 780
Posted By JamesHealey

My cars won a few races, wanna buy it?

My cars won a few races, wanna buy it?
Forum: Onroad Nitro Engine Zone
04-15-2016, 11:27 PM
Replies: 18
Views: 8,191
Posted By JamesHealey

WD40 contains silicone which causes extreme wear...

WD40 contains silicone which causes extreme wear to the piston surface, if you are using WD40 in your engine you will lose compression very quickly.
Forum: Onroad Nitro Engine Zone
04-15-2016, 01:12 AM
Replies: 18
Views: 8,191
Posted By JamesHealey

Different philosophy I guess, I clean out with...

Different philosophy I guess, I clean out with brake cleaner and oil with Novarossi rebuild oil after a wet race, but after a dry day I just leave the engine alone because quality fuel oils the...
Forum: Nitro On-Road
04-14-2016, 11:13 PM
Replies: 43
Views: 4,364
Posted By JamesHealey

Of course team drivers are running prototypes and...

Of course team drivers are running prototypes and testing new parts, they're pushing development for next years car.

I see Mark Green testing development parts all the time, and he's usually...
Forum: Onroad Nitro Engine Zone
04-13-2016, 05:09 AM
Replies: 18
Views: 8,191
Posted By JamesHealey

If you must clean your engine out just use brake...

If you must clean your engine out just use brake cleaner and keep your thumb over the silicone insert to avoid getting any on that, and use Novarossi rebuild oil for the rebuild.

But doing this...
Forum: Onroad Nitro Engine Zone
04-13-2016, 05:07 AM
Replies: 18
Views: 8,191
Posted By JamesHealey

Do not use WD40 anywhere near your engine at all,...

Do not use WD40 anywhere near your engine at all, it's horrendous stuff and will ruin your engine.

Just do what Dan said, clean the engine components using the fuel you race with, and leave them...
Forum: Onroad Nitro Engine Zone
04-13-2016, 02:14 AM
Replies: 6,142
Views: 1,142,094
Posted By JamesHealey

If you are running the Shepherd, which it looks...

If you are running the Shepherd, which it looks like you are from your signature, the off-set carb Novarossi engines such as the Mito 7 & 9 and the Virtus will not fit properly into the car and allow...
Forum: Onroad Nitro Engine Zone
04-13-2016, 12:50 AM
Replies: 6,142
Views: 1,142,094
Posted By JamesHealey

The 7C or the 7?

The 7C or the 7?
Forum: Onroad Nitro Engine Zone
04-13-2016, 12:49 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

True the pipe combo's were completely different...

True the pipe combo's were completely different between the R2101 and the 9CL-WC, I will need to do some testing with the 41016 manifold at my next race to see how that compares to the OS, as I've...
Forum: Onroad Nitro Engine Zone
04-11-2016, 02:14 PM
Replies: 157
Views: 73,238
Posted By JamesHealey

I felt the R2101 pulled better through taller...

I felt the R2101 pulled better through taller gearing, but didn't reach the same RPM as the Ielasi, so you had to run the Nova engines geared quite short to get them to rev and produce the peak HP,...
Forum: Onroad Nitro Engine Zone
04-03-2016, 11:02 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

As Roelof has stated the crank shaft timing on...

As Roelof has stated the crank shaft timing on the 9CL WC engines is very aggressive, much higher than most standard Novarossi engines, a standard Novarossi 35 Plus 21 would normally have around 207...
Forum: Onroad Nitro Engine Zone
04-03-2016, 10:57 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

The "Spec" version of each engine has a hand...

The "Spec" version of each engine has a hand tuned crankshaft, and piston/liner as well as the ceramic bearing upgrade, the little extra money for the "Spec" version of the engine is for sure worth...
Forum: Onroad Nitro Engine Zone
04-03-2016, 02:10 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

Yes in short, the tuned "Spec" version of each...

Yes in short, the tuned "Spec" version of each engine is hand tuned and comes with a ceramic rear bearing. The Standard "On" version is steel bearings and not tuned.
Forum: Onroad Nitro Engine Zone
02-25-2016, 11:23 PM
Replies: 16
Views: 5,928
Posted By JamesHealey

I believe the bore/stroke changed also, came much...

I believe the bore/stroke changed also, came much closer to standard Picco specs.

They're good engines for sure!
Forum: Nitro On-Road
02-25-2016, 11:18 PM
Replies: 5
Views: 1,853
Posted By JamesHealey

Not yet, keep checking RedRC!

Not yet, keep checking RedRC!
Forum: Nitro On-Road
02-25-2016, 11:16 PM
Replies: 27
Views: 8,218
Posted By JamesHealey

I had a Savox 1258 steering servo fail on me at a...

I had a Savox 1258 steering servo fail on me at a National in 2013, it was luckily not during a fast section of the track and the damage was minimal.

I switched to Xpert RC servos in 2014 and...
Forum: Nitro On-Road
02-13-2016, 12:27 PM
Replies: 207
Views: 67,958
Posted By JamesHealey

The Shepherd Blue rear and red fronts are closer...

The Shepherd Blue rear and red fronts are closer to Mugen Whites.

The Shepherd white rear and blue fronts are close to Mugen Greys.
Forum: Onroad Nitro Engine Zone
02-13-2016, 07:48 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

Having discussed this with Daniele, he prefers...

Having discussed this with Daniele, he prefers the 16.8 stroke engines by Novarossi, and Simon Kurzbuch has just won the worlds on this type of engine.

A lot of the technology on the 9CL WC is...
Forum: Onroad Nitro Engine Zone
02-13-2016, 07:42 AM
Replies: 157
Views: 73,238
Posted By JamesHealey

Yes the 3CL shares a lot of parts with the Keep...

Yes the 3CL shares a lot of parts with the Keep On .12, but the timings are specific to Ielasi Tuned to improve power over stock, also a lot of work is done to the crankshaft, crankcase and sleeve to...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.