R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: crusey_aus
Showing results 1 to 25 of 500
Search took 0.06 seconds.
Forum: Electric Off-Road
03-20-2014, 09:23 PM
Replies: 69
Views: 33,931
Posted By crusey_aus

Assuming you are running 2s lipos, gear the car...

Assuming you are running 2s lipos, gear the car for 35 mph and monitor your motor temps

What ESC are you planning to use ?

Cheers
Forum: Electric Off-Road
03-20-2014, 08:14 PM
Replies: 69
Views: 33,931
Posted By crusey_aus

Wiring is no different to any other sensorless...

Wiring is no different to any other sensorless motor

Connect all three wires, if it spins in the wrong direction swap any two to reverse it

What car are you putting it in ?
Forum: Radio and Electronics
03-29-2013, 03:19 PM
Replies: 2
Views: 6,418
Posted By crusey_aus

Number of poles simply refers to the motors...

Number of poles simply refers to the motors construction

Assuming you are comparing motors from different manufacturers you may as well be comparing apples to oranges

What are the model numbers...
Forum: Radio and Electronics
03-19-2013, 04:33 PM
Replies: 6
Views: 4,071
Posted By crusey_aus

Disable punch control, set your start power at...

Disable punch control, set your start power at high and use good batteries

Once you calibrate the ESC with trims / EPA's set correctly you may eliminate some cogging by adding a small amount of...
Forum: Radio and Electronics
03-19-2013, 04:31 PM
Replies: 1
Views: 787
Posted By crusey_aus

Start with max punch and zero timing, gear the...

Start with max punch and zero timing, gear the car for the speed you need and go from there

Cheers
Forum: Radio and Electronics
03-10-2013, 11:29 PM
Replies: 44
Views: 4,344
Posted By crusey_aus

ESC's usually have two current ratings listed...

ESC's usually have two current ratings listed (continuous and burst)

Generally speaking they are referring to the components used in their construction (capacitors, transistors etc....)

Select...
Forum: Radio and Electronics
01-28-2013, 04:52 PM
Replies: 7
Views: 713
Posted By crusey_aus

Forget the silly capacitor Simply run an...

Forget the silly capacitor

Simply run an external bec (Castle ccbec)

Cheers
Forum: Radio and Electronics
01-28-2013, 04:51 PM
Replies: 15
Views: 26,314
Posted By crusey_aus

Easy to test the capacity of a lipo if you have a...

Easy to test the capacity of a lipo if you have a decent charger

Discharge down to 3.5v / cell and stop charger

Discharge again down to 3.0v / cell and take note of mah taken out (figure A)
...
Forum: Radio and Electronics
01-28-2013, 01:18 AM
Replies: 15
Views: 26,314
Posted By crusey_aus

LVC is activated when the pack is under load ...

LVC is activated when the pack is under load

The voltage recovers once the load is removed

The amount the voltage recovers depends on the load being applied

Cheers
Forum: Radio and Electronics
01-27-2013, 09:10 PM
Replies: 15
Views: 26,314
Posted By crusey_aus

Thats not correct at all A lipo cell is...

Thats not correct at all

A lipo cell is energy depleted (empty) at around 3.5v resting, no reason to ever take them that low

Cheers
Forum: Radio and Electronics
01-24-2013, 03:01 PM
Replies: 91
Views: 3,518
Posted By crusey_aus

In the Hood !

In the Hood !
Forum: Radio and Electronics
01-22-2013, 11:07 PM
Replies: 3
Views: 718
Posted By crusey_aus

Nimh setting 0.2 - 0.5 amps or so charge...

Nimh setting

0.2 - 0.5 amps or so charge rate

1 amp if you are in a hurry

Cheers
Forum: Radio and Electronics
01-21-2013, 08:12 PM
Replies: 21
Views: 12,858
Posted By crusey_aus

Throw it in your car and run it for a few minutes...

Throw it in your car and run it for a few minutes

Cheers
Forum: Radio and Electronics
01-20-2013, 03:07 PM
Replies: 2
Views: 770
Posted By crusey_aus

A 2s2p pack is made up of 4 x 2500 mah cells ...

A 2s2p pack is made up of 4 x 2500 mah cells

Cheers
Forum: Radio and Electronics
01-17-2013, 06:31 AM
Replies: 3
Views: 1,033
Posted By crusey_aus

These are the bomb ...

These are the bomb

http://9rc.com/9turbo/index.php?main_page=product_info&cPath=1&products_id=9&zenid=2d0ebdb1989e9acc231efeb1e29bd4d4


Cheers
Forum: Radio and Electronics
01-12-2013, 12:40 AM
Replies: 12
Views: 9,047
Posted By crusey_aus

Hobbywings do not have a dual mode (start in...

Hobbywings do not have a dual mode (start in sensored, change to sensorless)

The Castle MMP and Tekin RX8 do

Cheers
Forum: Radio and Electronics
01-12-2013, 12:38 AM
Replies: 7
Views: 760
Posted By crusey_aus

Higher charge rate will terminate at a slightly...

Higher charge rate will terminate at a slightly lower resting voltage, but the difference wont be noticeable for most people

Cheers
Forum: Radio and Electronics
01-10-2013, 09:17 PM
Replies: 5
Views: 734
Posted By crusey_aus

You can change the LVC without Castle link ...

You can change the LVC without Castle link

Manual programming is listed in the Castle drivers guide manual for the ESC (available online)

If the dodgy battery is new send it back to the...
Forum: Radio and Electronics
01-10-2013, 09:13 PM
Replies: 5
Views: 498
Posted By crusey_aus

Exactly, EPA or traning mode are not good...

Exactly,

EPA or traning mode are not good for the ESC

Gear the car correctly for the speed you want at 100% wide open throttle

Cheers
Forum: Radio and Electronics
01-10-2013, 01:55 PM
Replies: 5
Views: 734
Posted By crusey_aus

Not unusual for packs to hold more than their...

Not unusual for packs to hold more than their listed capacity

What is your LVC set for ? It sounds a little low

A lipo cell is basically energy depleted (empty) at a resting voltage of 3.5v
...
Forum: Radio and Electronics
01-10-2013, 01:16 PM
Replies: 5
Views: 498
Posted By crusey_aus

Smaller pinion / Larger spur Run 2s instead of...

Smaller pinion / Larger spur
Run 2s instead of 3s

Cheers
Forum: Radio and Electronics
01-10-2013, 01:12 PM
Replies: 5
Views: 734
Posted By crusey_aus

If you want them to last a while you should be...

If you want them to last a while you should be aiming to add 80% of your packs rated capacity

Set your LVC for 3.5v / cell and have them come out of the car at around 3.7v / cell

If you are...
Forum: Radio and Electronics
01-09-2013, 01:08 PM
Replies: 8
Views: 6,707
Posted By crusey_aus

Revolectrix Powerlab 6 or 8 However if you...

Revolectrix Powerlab 6 or 8

However if you want accuracy, spend a few bucks and buy one of Wayne Giles' dedicated ESR meters

http://www.progressiverc.com/esr-meter.html

Cheers
Forum: Radio and Electronics
01-06-2013, 04:07 PM
Replies: 4
Views: 1,111
Posted By crusey_aus

Why would they not work together ? My MMP...

Why would they not work together ?

My MMP has no problems handling a 6 pole motor (Tenshock X802) that will burst well over 160 amps on 4s in a Slash 4x4

Cheers
Forum: Radio and Electronics
01-06-2013, 04:04 PM
Replies: 4
Views: 745
Posted By crusey_aus

No Get a dedicated IR meter if you want the...

No

Get a dedicated IR meter if you want the job done properly

Or buy a high end charger and learn to parallel charge

Cheers
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.