R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 3
1
2
3
Search: Posts Made By: Racer-rich
Showing results 1 to 25 of 59
Search took 0.01 seconds.
Forum: Nitro On-Road
09-03-2014, 11:32 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

No, the images do not seem to be accessible by...

No, the images do not seem to be accessible by others. Maybe there are permission problems where the images are stored?

-Rich
Forum: Nitro On-Road
08-23-2014, 08:19 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Great! Post some pictures of the finished car as...

Great! Post some pictures of the finished car as we would like to see the finished project.
-Rich
Forum: Nitro On-Road
04-06-2014, 10:34 AM
Replies: 1,114
Views: 206,075
Posted By Racer-rich

Hi, try here: ...

Hi, try here:
http://www.the-border.com/Kyosho-SPADA-09/
-Rich
Forum: Nitro On-Road
11-24-2013, 08:16 PM
Replies: 1,114
Views: 206,075
Posted By Racer-rich

Hi, Since this car has front wheel drive the...

Hi,
Since this car has front wheel drive the front steering Setup is unique. However you can adjust the servo (wheel) throw by using a smaller size servo horn or maybe even go to a single point...
Forum: Nitro On-Road
11-24-2013, 07:57 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi, When you use the two speed you will have...

Hi,

When you use the two speed you will have to modify the battery holder as shown in the instructions. What I did was to use a lipo battery and mount it in the same place as the original (behind...
Forum: Nitro On-Road
11-17-2013, 07:14 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Gary, Great job! Your car looks great....

Gary,
Great job! Your car looks great. Actually, the kit rubber tires aren't to bad on an asphalt track. But foam tires are much better.

-Rich
Forum: Nitro On-Road
11-04-2013, 08:01 PM
Replies: 1,114
Views: 206,075
Posted By Racer-rich

Hi, Just get a standard receiver switch for...

Hi,
Just get a standard receiver switch for your brand of receiver and plug the battery connector into the three wire female connector of the switch checking to make sure that the positive and...
Forum: Nitro On-Road
08-28-2013, 09:59 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi Jeff, When you use the two speed you will...

Hi Jeff,
When you use the two speed you will have to modify the battery holder as shown in the instructions. What I did was to use a lipo battery and mount it in the same place as the original...
Forum: Nitro On-Road
08-22-2013, 10:06 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi, I was also at the rams-rc WCC race last...

Hi,
I was also at the rams-rc WCC race last weekend. I was driving the solid red F1 car (the one that had the nose bent up in the A-main). At Nor-Cal I bring my Kf01 to all the on-road races and...
Forum: Nitro On-Road
08-11-2013, 05:34 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi, The stock plug works great with the stock...

Hi,
The stock plug works great with the stock engine. The stock glow plug is a "cold to medium" heat range plug. However if you are going to use some fuel with a really high level of nitro then you...
Forum: Nitro On-Road
08-04-2013, 08:31 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

I am in the San francisco, Ca. bay area (San...

I am in the San francisco, Ca. bay area (San Jose). I normally race at Nor-Cal hobbies and 1/5 scale at RAMS.

-Rich
Forum: Nitro On-Road
07-31-2013, 10:52 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Great to see another kf01 get on the track! ...

Great to see another kf01 get on the track!
There are a lot of tire vendors out there who's tires and rims will work. Such as Exceed and Kyosho (basically any f101-104 style wheels will fit, even...
Forum: Nitro On-Road
07-28-2013, 10:48 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

I am getting around 7 minutes on a tank using...

I am getting around 7 minutes on a tank using 16%nitro. If you use a higher nitro level you will get lower mileage as the engine will be running richer. Also I have an access hole in the body to...
Forum: Nitro On-Road
07-26-2013, 10:31 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi, I am sure that it is possible to install a...

Hi,
I am sure that it is possible to install a .12 size motor in the car, however you will need to create a lot of custom stuff to cram it in. For example the motor bolts directly to the chassis and...
Forum: Electric On-Road
07-17-2013, 10:35 AM
Replies: 6
Views: 1,790
Posted By Racer-rich

I race one competively and the only options that...

I race one competively and the only options that you really need are the high speed gear set and the rear sway-bar set to get the rear of the car to rotate better (to much rear grip). The rest are...
Forum: Nitro On-Road
06-10-2013, 10:23 AM
Replies: 8
Views: 5,752
Posted By Racer-rich

Hpi rs4 option parts

Hi,
There is an Asian company "ASIATEES" that sells a lot of option parts for hpi.
Here is a link to the company:
...
Forum: Nitro On-Road
06-01-2013, 11:26 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Motor tuneup

Hi,
This motor has two adjustment needles, the main fuel needle and the idle adjustment needle. The motor from the factory is set a little on the rich side for engine breakin reasons. Please see the...
Forum: Nitro On-Road
05-04-2013, 09:59 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Starting car without starter box

No, the motor does not have a pull starter or any way to spin the motor over with out the using something to rotate the flywheel. Bonsai hobbies has a starter box for $35 that is made for the KF01.
...
Forum: Radio and Electronics
04-03-2013, 10:35 AM
Replies: 11
Views: 1,002
Posted By Racer-rich

Steering and throttle swapping

Hi,
The easiest way to do this is by swapping the steering and throttle servo connections at the receiver. I.E. just move the steering servo connection to the throttle connector and do the similar...
Forum: Nitro On-Road
03-13-2013, 10:05 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi Fritzzz and NutDriver, Have you put together...

Hi Fritzzz and NutDriver,
Have you put together your kf01's yet? I would be interested to hear if you had any problems etc.

-Rich
Forum: California Racing
03-12-2013, 10:39 AM
Replies: 601
Views: 194,386
Posted By Racer-rich

FGX chassis fit?

Hi,
I love the look of the body. Would a 3Racing FGX F1 chassis fit with this body? The wheel base should be ok as it is simular to the F104 and the battery sits inline in the center of the chassis...
Forum: Nitro On-Road
02-26-2013, 09:59 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Starter box

Hi,
That starter box is a little big but it could still work for you. The space between the cars rear wheels is only 110mm so the rear tires will be touching the box as you start. So you will have...
Forum: Banzai Hobby
02-22-2013, 05:14 PM
Replies: 3
Views: 917
Posted By Racer-rich

Type 3 KF01 kit

Hi,
Looking at the actual page on The bonazi hobby website it seems that this is just the normal kit but with the type 3 body included (instead of the McLaren body). It is not the SP version of the...
Forum: Nitro On-Road
02-21-2013, 11:24 AM
Replies: 101
Views: 21,054
Posted By Racer-rich

Starter box

Hi,
A bump starter is just another name for a starter box. The "bump" name comes from the act of bumping the car down onto the starter box to spin up the starter box's wheel as you push down on the...
Forum: Nitro On-Road
02-17-2013, 07:27 PM
Replies: 101
Views: 21,054
Posted By Racer-rich

Hi, I am now racing the KF01 locally and I love...

Hi,
I am now racing the KF01 locally and I love the car! The options that you listed definitely improve performance on the track. You might want to consider also getting the stainless steel front...
Showing results 1 to 25 of 59
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.