R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: Suteki
Showing results 1 to 10 of 10
Search took 0.05 seconds.
Forum: Electric Off-Road
09-12-2012, 12:55 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

I take it you mean the white cable from the ESC...

I take it you mean the white cable from the ESC connection to RX? It would be soldered to the board.

Also don't worry about answering my question on the fan. It was stuttering when I went out...
Forum: Electric Off-Road
09-11-2012, 02:47 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

Quick question regarding the fan. When I first...

Quick question regarding the fan. When I first turn the ESC on the fan goes full speed, however I've found that after running my vehicle for a few minutes, when I pull the car off the track the fan...
Forum: Electric Off-Road
04-12-2012, 03:22 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

Whats a good custom LVC setting to use? I...

Whats a good custom LVC setting to use? I understand that if you just select the battery voltage it cuts off at 3v per cell, however I noticed my Losi SCTE with pro4 4600 was causing my Gens Ace...
Forum: Electric Off-Road
03-25-2012, 09:29 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

Pfft. It was never new. They opened it and...

Pfft. It was never new. They opened it and modified it. In doing so they even melted parts of the case!

If the product was sold as brand new then you are entirely within your right to demand a...
Forum: Electric Off-Road
03-24-2012, 06:32 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

Interested in the response you get noddy as I am...

Interested in the response you get noddy as I am always reading conflicting reports on the internet about motor temps and gearing. So far as I know, gearing up (ie. higher gear ratio like 10:1 should...
Forum: Electric Off-Road
03-21-2012, 04:02 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

I am a little surprised to hear that to be...

I am a little surprised to hear that to be honest. I wouldnt say the top speed of the car is what i would have considered that fast, lots of torque, reaches top speed incredibly quickly but most...
Forum: Electric Off-Road
03-20-2012, 05:31 PM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

I am noticing my Gens Ace 40c hardcase 5000mah 2...

I am noticing my Gens Ace 40c hardcase 5000mah 2 cells are puffing after using them in my Losi (RX8 + 4600 pro 4). Whats the story on puffing, at what point is it too much? I've heard of pretty much...
Forum: Electric Off-Road
03-10-2012, 07:40 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

I am using a really cheap iron at the moment. I...

I am using a really cheap iron at the moment. I will eventually get a station with temp control etc. At the moment the units i use are just junk, i continually clean the tip, keep it tinned but the...
Forum: Electric Off-Road
03-10-2012, 07:05 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

My problem with doing this is that i am 'ok' with...

My problem with doing this is that i am 'ok' with soldering, not great. I would like to do a clean install i really would, but soldering on my RX8 pcb? Hmm would rather avoid it as i dont have the...
Forum: Electric Off-Road
03-10-2012, 12:51 AM
Replies: 18,851
Views: 2,128,901
Posted By Suteki

I had to extend the ESC wire going to the...

I had to extend the ESC wire going to the receiver as I had pinched the original wire; I thought it was 22awg but it seems to be 20awg, is there any problem soldering 22awg wire from the receiver to...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.