I want to make sure I'm doing this right as it's not getting power to my motor. I hold the power button until green, then I press it, it flashes and that sets the neutral. I pull throttle and it flashes and goes solid and that's full throttle. I press full brake and press the esc it flashes and goes blank for a second then flashes a bunch of times and I got no power to the motor. I made sure all my connections are good and the servo is getting power from the receiver. I'm running the dx4c spectrum controller and the receiver it comes it. Any help is great, thanks!

You may have to reverse the throttle servo setting in the radio to get it to link up.

Any luck?i have the same problem? neutral and throttle are calibrated, but brake doesn't...

you need to set D/R and EPA of brake to 100%. Hope it works