|
Originally Posted by Mavtop
(Post 14317128)
Solved.
Using a Spektrum SRS4210 with AVC. You cannot calibrate any ESC until you calibrate the AVC receiver. The solution was found at Tekin's website. Here is the link: Unforunately I have not reached the amount of posts needed to post the link. Just PM me. Alternatively you can use the search terms "spektrum tekin calibration" in google https://www.spektrumrc.com/ProdInfo/..._Manual_EN.pdf You must do this whether using AVC or not. If you are NOT using AVC, you must use two bind plugs: one in the BIND port, the other in the DISABLE port. After performing the TX/RX calibration, the standard ESC calibration will work normally. Fought this one all day trying to calibrate a Mamba Max Pro with this rx and a Spektrum DX4C. |
Originally Posted by n10cities
(Post 15086677)
Correct, you MUST perform the TX/RX calibration on page 8 of the SRS4210 receiver manual BEFORE attempting ESC calibration. Here is the link to the manual:
https://www.spektrumrc.com/ProdInfo/..._Manual_EN.pdf You must do this whether using AVC or not. If you are NOT using AVC, you must use two bind plugs: one in the BIND port, the other in the DISABLE port. After performing the TX/RX calibration, the standard ESC calibration will work normally. Fought this one all day trying to calibrate a Mamba Max Pro with this rx and a Spektrum DX4C. |
| All times are GMT -7. It is currently 03:48 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.