R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)
-   -   Hitec pad (https://www.rctech.net/forum/radio-electronics/875057-hitec-pad.html)

jose valadao 05-03-2015 08:06 PM
Hitec pad
 
Witch receiver do I use the hitec pad or do you use it on all receiver .

Dave H 05-04-2015 04:12 AM
Not sure what the pad is you are asking about?

jose valadao 05-05-2015 09:24 PM
The pad comes with the new servos

Mopar2Ya 05-05-2015 09:29 PM
You plug P.A.D. into an unused port on your receiver(any receiver powering a Hitec brushless servo). From Hitec:
June 2014: Brushless Servo Service Bulletin

While compatible with most radio control devices, the regenerative braking feature of the HSB-9XXX series servos may cause a problem if the device cannot accept a backflow of current. The types of devices that cannot accept this backflow are: Voltage Regulators, Power Safe Receivers and certain BEC circuits whether stand alone or integrated within an Electronic Speed Control. Check with the manufacturer or the Hitec website for a list of compatible models. If your device cannot accept a current backflow, then you must install a PAD (Power Absorbing Device - Hitec PN# 55756) as described in this manual. A PAD is included with every Hitec brushless servo.


All times are GMT -7. It is currently 01:41 PM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.