EzRun Power Cut
 

Hi Guys,

My dad is running a 35A EzRun ESC. It goes great, but then all of a sudden the power will drop right off (as if the low voltage cut off has come on). If he waits a little or gives the car a nudge the power will return.

Any ideas?

Ryan

bad battery..battery can not hold voltage..

it seems to be happening no matter what battery.

I had a similar problem recently with a different esc. The servo was drawing to much current overloading the internal bec and eventually the esc would cut out. Usually after 5 minutes or so. If I waited it worked fine again. What servo does he run?

then as R1 said next is esc bec is overtaxed. add a bec and remove red or center wire on esc rx plug..

Thanks for the advice. I'm a bit of a noob, could you please explain a little more? What is a BEC? what does it do?

Hi, I 've had several drives that mark and in some, especially depending on the battery, you must regularles cutting quite right lipo ( 3.0v , 3.2) , this may be due to low battery discharge ( C ) or a motor consuming .
Try cutting down lipo drive and see if it also takes a little more