Don't want to buy tips and it being not what I want or does not fit. Which tips do you use the the 951 iron for your Rc racing?

Thx

Anyone?

Do you know if it takes the same tips as the 936?

Looks like there are a lot on ebay.

Those are very difficult to see actual size. I've been through buying tips based on pics. Wasted money. I prefer someone to recommend a tip that has experience.

I have a few. Do you need just a chisel point?

I use the wide tip which I think is 5mm. Excellent for battery post, motor tap, ESC post. Need to turn down the temp to 1/2 for smaller job like on/off switch, circuit board unless get a smaller tip like 2.5mm smaller

Yes I do

Do you have part number?

Somewhere in the T15-DL32 range would be my choice. The 3.2mm wide, long chisel tip seems to work well for general ESC post and motor wiring, including the bullets I use on some stuff, on the 836 I have.

I'd probably go for the 5.2mm T15-DL552 only if I was doing old round cell ni-xx cells. Don't think it would fit in the ESC posts and connectors that I have very well. A lot smaller if doing any circuit board type stuff.

Your stuff may be different of course.

Hakko FX-951 Soldering Station - Tips

Roger that!

Drat, slow updating my post after checking my Hakko setup.

I will go with the dl32. Same tip size on my current hakko iron.

Now just looking for something with free shipping

I can get em cheap from work. What are you lookin price wise?

The t15-dl32 are all over $20 shippe to me