![]() |
HobbyWing EZRun SC10/SC8 Problem?
I am running a HobbyWing EZRun SC10/SC8 ESC in an Associated SC10 4x4 with a HobbyWing 4000kv motor and a 2S battery. The truck runs fine for about 2 to 3 minutes then only has about half power for about 8 to 10 seconds and finally shuts off. Once you turn it back on, it will run fine again for less than a minute and repeat the problem. The ESC is only getting up to about 115 degrees. Motor is not hot either. Any ideas?
|
Originally Posted by ninefifteen
(Post 11414359)
I am running a HobbyWing EZRun SC10/SC8 ESC in an Associated SC10 4x4 with a HobbyWing 4000kv motor and a 2S battery. The truck runs fine for about 2 to 3 minutes then only has about half power for about 8 to 10 seconds and finally shuts off. Once you turn it back on, it will run fine again for less than a minute and repeat the problem. The ESC is only getting up to about 115 degrees. Motor is not hot either. Any ideas?
Paul |
Sounds like lipo cutoff. Definitely check your settings. Did you try another battery?
|
Try manually programming your esc to the number of cells your running. Let us know the outcome
|
| All times are GMT -7. It is currently 04:20 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.