Tekin rx8 problem need help please
 

I just installed my tekin rx8 paired with a tekin 1900kv motor, I have it binded with a flysky gt3c and I keep getting these flashing lights. Just for experiment I hooked up an old Hpi 2.4g tx/rx and I no longer have these flashing lights, I don't know if this is normal but from what I read it is interference between esc and rx. I don't know if this problem is causing range issues but at about 50 yards I no longer have control please help I have included a video link below thanks in advance guys


http://i876.photobucket.com/albums/a...C96432562F.mp4

Get a better radio.

Great answer thanks

Just heard back from tekin:
It is normal when using the Flysky radio. That radio system
channel hops. When his occurs we see it and flash our "no
signal" fault. It will cause no issues running the system.

That contradicts what you described above about not having control at 50+ yards. Did you run that by them at Tekin?

Charged up battery's in the controller and problem solved lol sometimes u over look the small things just tested it and I get around 150 yards