bew79

iTrader: (3)

Hi, I've got a futaba R2104GF receiver that came with my 4pl. I'm using hitec servos that don't have the tabs on the connectors so I'm not sure which way I should plug the servos into the receiver. Would someone be able to tell which order pins/colours are on the receiver as I'm paranoid about getting the polarity wrong and damaging it. Can't find anywhere in the manual what it is.

Thanks.

WindDrake

iTrader: (13)

The slots cut in the left of the housing are for the usual Futaba J connector, so that tells us all we need to know.

The pinout from Left to Right, looking at the unit face-on, right-side up, like in this picture, is as follows.

Furthest left: PPM (White)
Middle: Power (Red)
Furthest Right: Ground (Black)

bew79

iTrader: (3)

Legend! Think I was just scared to damage my new radio, knew the knowledge on rctech would help. Thanks

AreCee

iTrader: (1)

Most receivers have the ground closest to the end/edge/outside.