New LRP Flow Esc
#1501
I had this happen and unfortunately nothing worked and I had to send it in to be reflashed.
#1502
#1503
Hey Luke, Three times I tried to do the update. The first time my computer was dead, next the updater failed to open properly and then 3rd time it wouldn't connect at all. I have used it several times to update firmware and never had a problem. I am going to stick with 5.4 as it seems the Universe is telling me to stick with it. I listen to the Universe and I am not happy with its decision.
See yah tomorrow. 5.0 vs 5.4
Mike
See yah tomorrow. 5.0 vs 5.4
Mike
If you pm me your email I can send you the V5 Firmware which is what all the team drivers here seem to use, wish I would of known this when I got mine, have since switched back to Hobbywing but miss the braking feel on the LRP so may give one another go with the right Firmware on
#1504
Tech Fanatic
iTrader: (12)
If you pm me your email I can send you the V5 Firmware which is what all the team drivers here seem to use, wish I would of known this when I got mine, have since switched back to Hobbywing but miss the braking feel on the LRP so may give one another go with the right Firmware on
What is the difference between the 4.7/5.4 and the 5.0 firmware?
Thank you
#1505
Explained in the fact sheets when you download them.
Specific firmware for stock, mod, onroad/off etc.
Specific firmware for stock, mod, onroad/off etc.
#1508
5.0 is the old stock software. 5.4 is the newer stock software
#1509
Tech Apprentice
Hi guys, is there any way to know what firmware version is in the speedy as i got it second hand, but I dont have the bridge . thanks in advance
Last edited by Dual Fuel; 02-16-2016 at 11:45 PM. Reason: being stupid
#1510
No, I don't know if any way except for the bridge. You can maybe narrow it down to a few firmwares based on how many programming modes you have access to but it gets trickier after that.
#1511
New LRP speed control coming soon
I'm hearing there will be a replacement for the LRP Flow released in Summer around July.
#1513
Tech Regular
Hey guys, im using my LRP FLOW with Trinity D4 13.t in blinky.
Any advices on setup ?
Any advices on setup ?
#1514
Tech Fanatic
iTrader: (12)
I hope this helps.
Denis
#1515
I think you can use 5.4 just change the brake mode from the default setting which is pretty bad IMO. I like the brakes on 4.7 better but 5.4 has much better throttle feel for stock.
I usually run5.4 firmware settings: 5,2,2,6,0,0,0
I usually run5.4 firmware settings: 5,2,2,6,0,0,0