help airtronics mx3x with sc10
 

Hi guys I'm new to the hobby and i need some help please. I just bought an mx3x radio and receiver and I want to put it in my sc10. I connected the esc (stock esc brushless )and servo and after I turned on everything I noticed the the esc takes a longer time to allow me to use the throttle than my original stock radio ,and also I cant stop the car to go in reverse. Besides this, the servo and the trottle work fine except that when I give "gas" and releive, the car doesnt stop but goes back in reverse .... like i said I'm new and I dont know much about this so if somebody can help, I appreciate it. Thanks

stock esc? is this the rtr sc10? the only thing i could see is page 21 final adjustments section step 6.

http://www.teamassociated.com/cars_a...anuals_setups/

do you have any documents for your esc that allows you to set it's throttle neutral brake range to the new tx

sorry i cant give more info then that as i have never played with the rtr kit. but pretty much all esc whether its cars or air need their range set to the tx

if it is the stock sc10 esc look at this

http://www.teamassociated.com/pdf/ca...206%202011.pdf

go to throttle calibration section

Problem resolved thanks. I had to set the new radio with the Esc , i dont know Why i Was thinking / expeting that every radio as the same neutral point .