ugh =[ , few hours ago I made a post about drag break on a Tekin RX8 so once I got my answer I figured I'd try the hotwire software. I installed the hotwire software, said I needed to update my esc and I said ok, after that I tried to make changes using the hotwire software and it wouldn't save my changes. Said the heck with it and was going to do it manually ... now my esc doesn't work. No lights turn on at all, just the fan. I can't even do a default reset. Any ideas or am I just hosed?

Sorry to post this type question here but Tekin forum could take days to register because I use hot mail, tech support is closed and I'm really dreading thinking I broke the esc.

Got my issues sorted, I had to flash the firmware.