Hyperion 615 Duo3 problem
 

Hi,

Having a problem with my charger. On bay one it acts as expected, however on bay two... I can push no more than 4.9 amps.. ever.

Max ampreage I have pushed on channel one was 12 amps... I dont' know what is going on.

I have 2 8000mah batteries that I charge as a 10s and one bay one I'll pull 8 amps bay 2 4.9. Needless to say I never get a true sync balance charge.

any suggestions? Oh I'm on the latest firmware, and this has occured since I've had it (4.7)

Thanks!

+

A shot in the dark perhaps, but make sure the power sharing is set to 50-50.

Thanks Very much Dave!

I figured it out last night and it was set to 90 for channel 1 :blush:

Can you only change that within the PC software?

I didn't see a provision where you could change it on the Charger.

No PC needed, it can be changed in user setup, on channel 1.