Servo issue..
03-11-2011 | 08:34 AM
#1
Thread Starter
Tech Rookie
Joined: Mar 2011
Posts: 2
Servo issue..
I have a Non named 80's 1/5th scale r/c im rebuilding.. I'm just trying to save the servo it has.. Normal servo have 3 or 4 wires... this one has 6.... two on the motor itself... Here are a couple of photo's... Im just wondering if theres a way to wire it up to a Futuba style... If not.. i will go buy a servo and custom mount it... just looking for a little in site... Thanks!
I tried putting pictures up of it and im getting a
"You are only allowed to post URLs to other sites after you have made a certain number of posts. You have not reached that limit yet."
I tried putting pictures up of it and im getting a
"You are only allowed to post URLs to other sites after you have made a certain number of posts. You have not reached that limit yet."
03-11-2011 | 09:11 AM
#3
Where is the Printed Circuit Board (PCB) for the servo...?
The two on the motor have to be controlled by something, & the 4 wires on the "pot" are what tell that something where it is at.
You have 2/3 of a servo there.
That looks fairly toy grade.
The two on the motor have to be controlled by something, & the 4 wires on the "pot" are what tell that something where it is at.
You have 2/3 of a servo there.
That looks fairly toy grade.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
