recently i wanted to try out the left handed kit on my dx3r and while doing so i noticed a little spring fall out so i was just wondering where does it go? who ever gives me the answer can have $5 as i am really desperate as i have a race tomorrow
thanks

Does the steering wheel return to center? It could be the steering return spring that fell out.

Does the throttle return to neutral? It could also be a spring from the throttle trigger. There might be 2 springs in the throttle - one for return from forward and one for return from reverse - or just one for return from both...

the steering doesnt return to center but the throttle does, i sent horizion hobbys a email and they just said it attached to the back
thanks for stating the obvious horizion
thanks

bump

Ok so you need to open up the Tx again and figure out exactly where the spring is supposed to go. Chances are it'll be pretty obvious; I.e.: pins with nothing attached, dangling levers, etc.

i opend it up and i found where one end goes but the other i have no idea, because of this i missed a race and now it looks like i will miss another

bump

i would realy appreciate a answer
thanks!

Have you contacted Spektrum yet?

i have and they just said there is a place you have to put it.
i would have never figured
they said i can send it in but i dont have time for that
thanks

Open up the radio... take a picture.... we cant tell ya if we cant see it.

I tried opening mine up to see if I could help. When I took the steering mechanism off I could see the spring inside behind the steering tension adjustment screw. Running in the same up-down direction it appeared. Not sure how it came out if you followed the directions, but hey stuff happens. I chickened out in going any further, wasn’t sure if I should start with the inner larger screws or the smaller outer ones. But I suspect the spring goes across 2 pins, one for each direction of wheel travel, assuming it’s like other radios I have dissected. Wiggle the wheel maybe you can see something.

If you can’t figure it out, perhaps send a PM to RCGaryK. He works for Horizon, maybe he could take some pictures to help you out. (You’re welcome Gary ) Good Luck.

yeah you have to take out the 4 outer screws
i realy am confused on where to put it, you would think its obvious but it realy isnt
thanks for the help anyway

OK, you owe me now though , especially since I haven't tried to put it back together yet.

And no, I'm not a professional photographer, why do you ask???

Hope this helps.

wow thats worring
i seem to have lost the whole arm that connects to the spring
thanks alot, pm me your paypal details