Tekin R1 ESC. question..
 

just bought this ESC:
Tekin R1 Pro
and this BL motor:
Novak SS Pro 13.5T motor

I know that the ESC is sensorless and that the motor is sensored, but i know i can use it anyway. (have checked)

One question:
on the motor it is a plug of some kind, problably stock on the novak ESCs. this plug contains 6 wires and on the ESC it is just 3 (black, white and red)
So my question to you guys is: Can i just cut this plug off and just use the 3 wires (red, white and black) ? and isolate the three others?

will this work? or is there somethings else?

I wouldn't cut them, just tie them off.

I cant get it to work. the 2 leds on each side on the ESC is constantly flashing!! cant fint the error code in the manual either... what have i done wrong?

I soldered the black wire on B on the ESC. and the red wire on R on the esc... The white wire should I ignore it says in tha manual if I am going to have fwd/brk/rew.. whats wrong?

Do you have all 3 wires from the motor connected to the ESC?

no. just got two. since it says in the instructions that if i want fwd/brk/rew I should only use the red and black wire....hmmm

OMG. I used the sensor cable!!!!!

now I understand.
on the motor it is three connectors. A B C. what is what?
A goes to?
B goes to?'
C goes to?

Do you have the capacitor solider on to the battery terminals on the ESC correctly?

The red and black are for a brushed motor.

A(motor) Goes to R (esc)--------Red
B(motor) Goes to W (esc)-------White
C(motor) Goes to B (esc)--------Black

hmmm, i will try this. thanks