Ezrun ESC
 

Hi Guys!

I just bought a Ezrun ESC and I am trying to set up according to the instructions, I am at the stage to calibrate the throttle and been finding difficulty...

The instructions states to Hold the "Set" button and then turn on the ESC until the the Red LED flashes, which i can achieve at times. Then it says to pull the controller throttle fully back and then push the set button once more in which u should get a Green LED flashing once with a "Beep" from the Motor...however i have tried this and it doesn't seem to work! I been searchin around for answers to no avail..:confused:

Can anyone give me a solution or have come across this problem?

Thanks in advance for your help!!

try reversing the throttle on your transmitter.let us know how this holds up and in what.i saw one on ebay without the program card for 35 shipped!

Thanks for your dethklok151!
I just found out i mis-connected the wires to my reciever....problem solved and i managed to get the throttle range calibrated!
Now the next problem is i got my program card with it - i connected it up to the ESC and battery and it doesn't seem to work at all ie. no numbers light up or anything!! Any Suggestions??

I have one.. make sure you have the esc plugged into the correct input on the card and the correct way. It is marked.

Make sure the battery is charged too.. then turn it on.

If it's not working, something may be wrong with either the card or the esc... i believe you can program it without the card, but it looks a bit complicated.


Jerome :tire::tire:

Turn on your radio. Hold the program button and turn on esc. First you'll need to set neutral so press the program button again. The go full throttle and press the program button and then go full brake and press the program button. Let me know if this helps, if not send me a PM and I'll try to help you the best I can.

Regards.

First plug the 3 wire connector to the program box, make sure it's kooed up right though and on the correct location on the box and then hook up your pack and turn on the ESC.

Are these things any good? Jerome, you said you own one right? How is it working for you?

Thanks for your relpies everyone, really appreciate the help in here!!
I managed to get it working - think it was cos i connected the ends incorrectly into the programme box! Now i can finally start building my Active A210SS, can't wait to get it up and running!

It's ok.. price was definitely good!

The motor endbell stripped out and won't screw back on.. had to JB Weld it...

Haven't really used it all that much.. I will let you know!


Jerome

hi,
I just recently brought a acme raptor brushless rc truggy with a brushless motor and esc i have tried every thing on youtube and I still cant get anything to work would it be better if I get a programme card as this is my 1st brushless rc car
please help!!!!!!!!