Receiver + Electronics = interference!
03-25-2008 | 09:25 AM
#1
Thread Starter
Tech Adept
Joined: Mar 2008
Posts: 150
From: sunny california, walnut
Receiver + Electronics = interference!
I have a F201 using
GTX and Airtronic 75mhz FM Micro Receiver(the square one).
When I stuffed them all into the lower deck close to each other. !!!Motor, ESC and receiver in a tight space!!! It glitches almost all channels!
Then I switched the same receiver into the F103GT (pan car alike) close to an Tamiya 101bk ESC and far away from the motor, it runs without a glitch even at its range limit.
I know the micro reveiver is single conversion, not very good when close to "noise". but it looks like the new airtronics 2.4Ghz receiver in sharp. I wonder if I go for 2.4Ghz can fix that. or go for the ABC&W JR receiver?
Any info or experience with receiver and layout and stuff?
GTX and Airtronic 75mhz FM Micro Receiver(the square one).
When I stuffed them all into the lower deck close to each other. !!!Motor, ESC and receiver in a tight space!!! It glitches almost all channels!
Then I switched the same receiver into the F103GT (pan car alike) close to an Tamiya 101bk ESC and far away from the motor, it runs without a glitch even at its range limit.
I know the micro reveiver is single conversion, not very good when close to "noise". but it looks like the new airtronics 2.4Ghz receiver in sharp. I wonder if I go for 2.4Ghz can fix that. or go for the ABC&W JR receiver?
Any info or experience with receiver and layout and stuff?
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
