|
Dumb question time.
Ive looked and havent seen it anywhere although im not sure how to phrase it searching. Back in my younger days the receivers had a battery pack or the battery eliminator switch. With these new ones does the receiver get the powerfrom the ecs? Im guessing it does but dont want to fry my electronics. Thank you in advance..
|
Yes. However if hookup more than one esc to the same receiver, you will most likely need to pull the red servo wire out of the connector of the slave esc.
|
Ok thank you. Im only running 1 esc .. why would you run 2? For crawlers running 2 motors?
|
The receiver gets its power from the ESC.
|
Originally Posted by godkingtitan
(Post 16180300)
Ok thank you. Im only running 1 esc .. why would you run 2? For crawlers running 2 motors?
|
Originally Posted by godkingtitan
(Post 16180300)
Ok thank you. Im only running 1 esc .. why would you run 2? For crawlers running 2 motors?
|
Originally Posted by godkingtitan
(Post 16180300)
Ok thank you. Im only running 1 esc .. why would you run 2? For crawlers running 2 motors?
*** Sidenote, while the Jetsam was not referenced as part of Project 21, parts from TheJANG's HongNor buggy were used for the Jetsam, more info on Project21 here: https://www.rcgroups.com/forums/show...-Monster-Truck |
| All times are GMT -7. It is currently 03:03 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.