Chargingcases.com
 

I recently got an icharger 406duo, an x6 and a 85w power supply. I am looking for a nice setup to get all the charging stuff to the track. I already use ridgid cases and chargingcases.com makes a system that mounts in to hold your icharger, power supply, etc.

Does anyone have any experience with their stuff or feedback on mounting an icharger in a case like that?

iCharger DIY Ridgid V2 - 406 DUO Charging Case Kit – ChargingCases.com

In the RC heli world charge cases are quite possible. My last interaction with this company was good. Been awhile but I imagine they haven't changed.

I recently ordered a custom iCharger DX6 charging case for a NANUK 915 because I use NANUK for my hard side DJI drone and camera cases. Rick was really helpful selecting the case size.

Notes

• Didn’t come with instructions and the link to instructions doesn’t work.
• The M3 machine screws might be a little short for NANUK, but seem to hold fine.
• The RL Power charger power cable has a long and super stiff heat shrink wrap on the XT90. The hole for the power cable could stand to be a couple mm further back.
• Not sure how other cases mount the power supply and charger, but this relies on heavy duty 3M Velcro.
• I had to solder the fan wires to the 4mm bullets on the charger power supply.
• I went with the mini RL Power to reduce weight.

Part list

• NANUK 915
• iCharger DX6
• RL Power XT90 Charger Power Cable
• RL Power Limited Edition MINI 70 AMP Power Supply

https://cimg0.ibsrv.net/gimg/www.rct...0bc211858.jpeg
https://cimg2.ibsrv.net/gimg/www.rct...7fd8f8827.jpeg