Go Back  R/C Tech Forums > General Forums > Radio and Electronics
Hitec x4. Low voltage error >

Hitec x4. Low voltage error

Community
Wiki Posts
Search

Hitec x4. Low voltage error

Thread Tools
 
Search this Thread
 
Old 04-29-2018 | 12:34 PM
  #1  
Thread Starter
Tech Rookie
 
Joined: Nov 2011
Posts: 3
Default Hitec x4. Low voltage error

My Hitec charger gives me an error code, Battery voltage low. Is there any way charge this battery? I hate to scrap a battery because of this.
cemack54 is offline  
Old 04-29-2018 | 04:08 PM
  #2  
rustyus's Avatar
Tech Master
iTrader: (1)
 
Joined: Apr 2014
Posts: 1,296
From: PA
Default

Possibly thinking about using NiMh chemistry setting to bring up voltage on a LiPo pack? Only do it until voltage of cells is above 3v/cell, then try a balance charge again.

How low did the voltage drop? If a LiPo pack was discharged too much, battery health could have been diminished greatly.
rustyus is offline  
Old 04-29-2018 | 06:30 PM
  #3  
Thread Starter
Tech Rookie
 
Joined: Nov 2011
Posts: 3
Default

The batteries have not been charged for a few months. They were fine when they were last used. I probably did not store them correctly.
cemack54 is offline  
Old 04-29-2018 | 06:43 PM
  #4  
Thread Starter
Tech Rookie
 
Joined: Nov 2011
Posts: 3
Default

I tried your suggestion and it worked! Thanks a lot. I just saved 3 older batteries.
cemack54 is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.