FS: SCX10 highly modified with Losi Comp Crawler drivetrain & stock parts
#1
SOLD: SCX10 highly modified with Losi Comp Crawler drivetrain & stock parts
I need a new computer, and I don't think I'm gonna use this too much over the summer, so here goes. It's an Axial SCX10 Dingo kit, but I went out and bought a Losi Comp Crawler and took the entire drivetrain out of it and used it in the SCX10. It has worm gears, external grease port, V3 CVDs (the good ones) and yes, a DIG. Comes with all the stock/original parts as well as all the losi parts, so if you wanted to you could build it back into two complete trucks. This thing will destroy some pretty tough courses, the reason I built it this way is the losi axles give you more steering angle, nice CVDs, more ground clearance because the pumpkin is smaller, and full self locking (basically better than any drag brake could possibly be).
On it right now:
-Castle SV3 ESC just put in a few weeks ago
-Castle 10A BEC
-Dewalt motor with about 15 minutes on it
-Bluebird BMS-660 digital metal gear servo
-Hitec dig servo
-Proline 2.2 beadlocks/Hot Bodies 2.2 tires
-Losi aluminum caster blocks
-TWO sets of Losi 4" shocks
-Front and rear LED lighting with a custom made power supply (fronts are VERY bright, rears are dimmer for scale)
-Axial Jeep bumper
Parts included with the Axial drivetrain:
-Novak Terra Claw 35t motor
-Gmade 1.9 beadlocks/Axial ripsaw 1.9 tires
-Axial aluminum knuckles
Also included is a nice winch setup with a modified Hitec 645 metal gear servo, metal servo horn and metal sewing bobbin with a nice steel cable. Powered by a Tamiya ESC so it can run on 2s lipo and has PLENTY of torque to pull the truck straight up a wall.
SOLD
See all the pictures here: http://imgur.com/a/z75gb
On it right now:
-Castle SV3 ESC just put in a few weeks ago
-Castle 10A BEC
-Dewalt motor with about 15 minutes on it
-Bluebird BMS-660 digital metal gear servo
-Hitec dig servo
-Proline 2.2 beadlocks/Hot Bodies 2.2 tires
-Losi aluminum caster blocks
-TWO sets of Losi 4" shocks
-Front and rear LED lighting with a custom made power supply (fronts are VERY bright, rears are dimmer for scale)
-Axial Jeep bumper
Parts included with the Axial drivetrain:
-Novak Terra Claw 35t motor
-Gmade 1.9 beadlocks/Axial ripsaw 1.9 tires
-Axial aluminum knuckles
Also included is a nice winch setup with a modified Hitec 645 metal gear servo, metal servo horn and metal sewing bobbin with a nice steel cable. Powered by a Tamiya ESC so it can run on 2s lipo and has PLENTY of torque to pull the truck straight up a wall.
SOLD
See all the pictures here: http://imgur.com/a/z75gb
Last edited by ZiG-87; 06-14-2014 at 09:50 AM.
#2
up!
#3