Mugen MBX6/R Parts: Springs, Sway Bars, Savox Servo
#1
Mugen MBX6/R Parts: Springs, Sway Bars, Savox Servo
SOLDNot racing the MBX6 anymore. I've got these leftovers; (L) rear arm, (L) front arm, (L) upper front arm, MUGE0579 full spring set - very little use; the front 7.5 and rear 7.75 are still new in the package - 2.5 and 2.6 front sway bars, 3.0 rear sway bar, one lucky 7 preoiled filter and lastly a Savox SC-1267SG High Voltage servo.
The Hudy aluminum servo horn was a very tight fit when originally installed on the servo and i'm now afraid to take the horn off; It is on there very tight! The servo has no issues and works fine; though the wires near the plug show wear from being folded over in the receiver box. Check out the picture.
Looking for SOLD shipped within the states. Thank you.
The Hudy aluminum servo horn was a very tight fit when originally installed on the servo and i'm now afraid to take the horn off; It is on there very tight! The servo has no issues and works fine; though the wires near the plug show wear from being folded over in the receiver box. Check out the picture.
Looking for SOLD shipped within the states. Thank you.
Last edited by newob; 04-15-2013 at 01:38 PM.
#2
morning bumpage.