TREX 600 Bind and Fly *MINT*
02-26-2013, 03:02 PM
#1
TREX 600 Bind and Fly *MINT*
TREX 600 Nitro Bind and Fly
Selling my TREX600 Limited Edition. I built it early last summer with all new components.
Has about 10 flights on it including the break-in and everything is still in like new condition
This heli flies fantastic and is perfectly stable.
No crashes, no hard landings, it was babied.
Everything here is like new!
Spartan Quark
Spartan Flash Link
SLX Quark adapter
O.S. Hyper Max 55HZ
Pushglo Glow ignitor
Fun Tech Tuned Pipe
AR7100 7 channel Spectrum receiver with satellite
Outrage 3600mah 2S lipo RX pack
Aerospire Multigov Pro with LCD programmer
3 Align DS610 servos for Cyclic
1 Align DS620 servo for throttle
1 Futaba BLS251 for rudder
1 set of Curtis Youngblood Radix main blades.
1 set of Curtis Youngblood CF tail blades.
2 sets of Align Blades
Heli is set up perfectly, all you need to do it bind your Spektrum radio and fly.
$800 obo shipped lower 48 - paypal Will also consider trades for race ready LOSI SCTE or 1/5 scales
Selling my TREX600 Limited Edition. I built it early last summer with all new components.
Has about 10 flights on it including the break-in and everything is still in like new condition
This heli flies fantastic and is perfectly stable.
No crashes, no hard landings, it was babied.
Everything here is like new!
Spartan Quark
Spartan Flash Link
SLX Quark adapter
O.S. Hyper Max 55HZ
Pushglo Glow ignitor
Fun Tech Tuned Pipe
AR7100 7 channel Spectrum receiver with satellite
Outrage 3600mah 2S lipo RX pack
Aerospire Multigov Pro with LCD programmer
3 Align DS610 servos for Cyclic
1 Align DS620 servo for throttle
1 Futaba BLS251 for rudder
1 set of Curtis Youngblood Radix main blades.
1 set of Curtis Youngblood CF tail blades.
2 sets of Align Blades
Heli is set up perfectly, all you need to do it bind your Spektrum radio and fly.
$800 obo shipped lower 48 - paypal Will also consider trades for race ready LOSI SCTE or 1/5 scales
Last edited by Izumi63; 03-05-2013 at 07:26 AM.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
