Losi Xcelorin 1/8th Scall 2400kv motor
06-15-2011, 02:23 AM
#1
Losi Xcelorin 1/8th Scall 2400kv motor
Like the title says, I am selling a Losi 2400kv 1/8th scale motor.
As you can see I had 4-40 screws installed on the front part of the can. These were professionally installed by a machinist. These will prevent the can from falling apart due to forces of offroad use. Every racer in the DFW area that is running one of these motors has this done to prevent any damage to the motor. I also showed a pic of the slight scuff on the rear of the motor can.
I stopped using it because I went with a lower KV motor to slow myself down
I am looking to get $90 shipped for the motor.
Thanks
- Used for 2 weeeks
- Less than 25 packs ran through it
- Upgraded can screws
- Never saw above 160 degree temps
As you can see I had 4-40 screws installed on the front part of the can. These were professionally installed by a machinist. These will prevent the can from falling apart due to forces of offroad use. Every racer in the DFW area that is running one of these motors has this done to prevent any damage to the motor. I also showed a pic of the slight scuff on the rear of the motor can.
I stopped using it because I went with a lower KV motor to slow myself down
I am looking to get $90 shipped for the motor.
Thanks
06-15-2011, 01:46 PM
#2
bump
07-02-2011, 03:04 AM
#3
bump for a good motor
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
