PRS 64 pitch pinions and RPM pinion case
11-21-2010, 07:47 AM
#1
SOLD: PRS 64 pitch pinions and RPM pinion case
SOLD!
Five PRS 64 pitch pinions. 42, 44, 45, 46, and 50 teeth. The 50-tooth one has the tooth count etched into the collar from the factory, but the other ones do not, so i used a silver sharpie to write on them -- the sharpie can be removed with some motor spray if you want. Most of the pinions were never used. Only use was in a Losi xxx-s Vintage Trans Am car with a 21.5 motor in an enclosed gear area. No damage and all like new.
All set screws are present.
The RPM case is in perfect shape. These things are a great way to store pinions and normally sell for $8.50. The excellent PRS pinions usually sell for $5.50 each. That's about $36 worth of great stuff.
Shipped. Paypal'd. US. $30 obo.
Five PRS 64 pitch pinions. 42, 44, 45, 46, and 50 teeth. The 50-tooth one has the tooth count etched into the collar from the factory, but the other ones do not, so i used a silver sharpie to write on them -- the sharpie can be removed with some motor spray if you want. Most of the pinions were never used. Only use was in a Losi xxx-s Vintage Trans Am car with a 21.5 motor in an enclosed gear area. No damage and all like new.
All set screws are present.
The RPM case is in perfect shape. These things are a great way to store pinions and normally sell for $8.50. The excellent PRS pinions usually sell for $5.50 each. That's about $36 worth of great stuff.
Shipped. Paypal'd. US. $30 obo.
Last edited by BobWoodhouse; 11-27-2010 at 04:17 AM. Reason: sold
11-24-2010, 06:13 PM
#2
They are still available.
11-26-2010, 06:16 AM
#3
If the RPM case is not your style, I could sell the pinions only. I like that case a lot and could stand to keep it myself if a lower amount for the pinions only matches your needs. You know, these are some fairly light, but very good pinions.
11-26-2010, 11:35 AM
#5
OK. Entering Paypal phase.
11-26-2010, 05:49 PM
#6
paypal received.
need shipping address.
need shipping address.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
