FS: Associated LRP Vector 6.5 Turn Brushless Motor and Sphere ESC
#1
FS: Associated LRP Vector 6.5 Turn Brushless Motor and Sphere ESC
Nearly mint condition after a small time in my CRT.5. Good as the day the box was opened with all included paperwork, stickers, wires, ties, heatsink, screwdriver, etc. Came as a set from LRP for just under $300. Yours for $200 shipped to the lower 48 states. Trades will be entertained but I don't have anything in mind really. You can see what I run below in my sig. Below is the stats on it and below will be a stock pic of it. I'll take a few shots of it tomorrow for anybody interested. If you're looking for a brushless conversion for your CRT.5 then stay tuned as I'm pulling it all over the weekend for a conversion back to nitro.
This is the Associated LRP Vector 6.5 Turn Brushless Motor and
#80500 Sphere Electronic Speed Control.
Motor;
FEATURES: Standard 540 size and weight brushless sensorless design
Adjustable timing
Military spec bonded neodymium magnet
Oversize low friction ball bearings
Low resistance multilayer PCB
ROAR, EFRA, IFMAR, BRCA and DMC legal
Speed Control;
Compatible with brushed motors down to 7 turns and sensorless
brushless motors down to 5.5 turns
Four adjustable modes; Brushless/Brushed, Punch, Initial-Brake and
Auto-Brake
Three way multi protection system for overload, thermal and short
protection
External solder tabs
100% digital technology
Ninety day limited warranty on motor and speed control
INCLUDES: Associated LRP Vector 7.5 Turn Brushless Motor, wire leads with
bullet connectors, Hall sensor wire, Sphere Speed Control, heat
sink, motor wires with bullet and spade connectors, Tamiya battery
connector, screwdriver, double-sided tape, four zip ties, three
capacitors and instruction sheet
REQUIRES: Installing in vehicle
SPECS: Motor;
RPM: 49,680 U/min
Specific RPM per Volt, kv: 6,900 RPM/volt
Power: 332W at 7.2V
Efficiency: 92%
Magnet Material: Bonded
Minimum Requirements for Speedo: LRP Sphere Brushless and Brushed
digital
Winding: Star
Hall Sensor Pin Assignment: Compliant to IFMAR/EFRA/ROAR/BRCA and
DMC rules
Shaft Diameter: 0.12" (3.2mm)
Can Length: 2.1" (53.3mm)
Can Diameter: 1.4" (36mm)
Weight: 5.96oz (169g)
Speed Control;
Case Size: 1.3 x 1.5" x 0.59" (33.1 x 37.6 x 14.9mm)
Weight: 0.86oz (24.5g)
Voltage Input: 4-7 cells (4.8-8.4V)
Typical Voltage Drop (Brushless) @20A: 0.035V/phase
Typical Voltage Drop (Brushed) @20A: 0.026V/phase
Rated Current (Brushless): 200A/phase
Rated Current (Brushed): 200A
BEC: 5.5V
Battery Connector: Standard Tamiya
High Frequency: Yes
This is the Associated LRP Vector 6.5 Turn Brushless Motor and
#80500 Sphere Electronic Speed Control.
Motor;
FEATURES: Standard 540 size and weight brushless sensorless design
Adjustable timing
Military spec bonded neodymium magnet
Oversize low friction ball bearings
Low resistance multilayer PCB
ROAR, EFRA, IFMAR, BRCA and DMC legal
Speed Control;
Compatible with brushed motors down to 7 turns and sensorless
brushless motors down to 5.5 turns
Four adjustable modes; Brushless/Brushed, Punch, Initial-Brake and
Auto-Brake
Three way multi protection system for overload, thermal and short
protection
External solder tabs
100% digital technology
Ninety day limited warranty on motor and speed control
INCLUDES: Associated LRP Vector 7.5 Turn Brushless Motor, wire leads with
bullet connectors, Hall sensor wire, Sphere Speed Control, heat
sink, motor wires with bullet and spade connectors, Tamiya battery
connector, screwdriver, double-sided tape, four zip ties, three
capacitors and instruction sheet
REQUIRES: Installing in vehicle
SPECS: Motor;
RPM: 49,680 U/min
Specific RPM per Volt, kv: 6,900 RPM/volt
Power: 332W at 7.2V
Efficiency: 92%
Magnet Material: Bonded
Minimum Requirements for Speedo: LRP Sphere Brushless and Brushed
digital
Winding: Star
Hall Sensor Pin Assignment: Compliant to IFMAR/EFRA/ROAR/BRCA and
DMC rules
Shaft Diameter: 0.12" (3.2mm)
Can Length: 2.1" (53.3mm)
Can Diameter: 1.4" (36mm)
Weight: 5.96oz (169g)
Speed Control;
Case Size: 1.3 x 1.5" x 0.59" (33.1 x 37.6 x 14.9mm)
Weight: 0.86oz (24.5g)
Voltage Input: 4-7 cells (4.8-8.4V)
Typical Voltage Drop (Brushless) @20A: 0.035V/phase
Typical Voltage Drop (Brushed) @20A: 0.026V/phase
Rated Current (Brushless): 200A/phase
Rated Current (Brushed): 200A
BEC: 5.5V
Battery Connector: Standard Tamiya
High Frequency: Yes
#3
Alright, pics up. I'd like $60 for the batt and $200 for the ESC/6.5 combo. Open to trades but I like the color of money. Prices are shipped to your door and pardon the pics. Appearently, cameras are just like RC's, you get what you pay for.
http://picasaweb.google.com/rcsavage...62557594237762
http://picasaweb.google.com/rcsavage...62566184172370
http://picasaweb.google.com/rcsavage...62583364041570
http://picasaweb.google.com/rcsavage...62591953976178
http://picasaweb.google.com/rcsavage...62557594237762
http://picasaweb.google.com/rcsavage...62566184172370
http://picasaweb.google.com/rcsavage...62583364041570
http://picasaweb.google.com/rcsavage...62591953976178
#5
I will trade you my 8GB ipod touch for it..... maybe
#7
Yeah but that isn't what I use it for a whole lot, you can browse the internet, check your e-mail stuff like that. Plus it is an Mp3 player..... have you ever seen one? http://www.apple.com/ipodtouch/guidedtour/
I don't know...... haha I gotta think about this. Let me know if you are interested and I will take some pics.
I don't know...... haha I gotta think about this. Let me know if you are interested and I will take some pics.