TC clearing, HPI Pro4 aftermarket parts, batteries, motors
12-19-2006, 09:35 PM
#1
TC clearing, HPI Pro4 aftermarket parts, batteries, motors
PRO 4 PARTS
i have a few after market parts i no longer use/need. both have only been used once.
- MIP shinny CVDs only used once absolutely brand new condition, no wear on them at all. asking $25 shipped
- Square purple aluminum rear hubs. one has a scratch on it but not to major but still in great condition asking $25 shipped
Batts
3x Fusion Team 3700s, AV 1.189-1.1886 IR 2.3
pro built. been sitting for a while but stored them fully charged so i think they need to by cycled once or twice. the shrink wrap if falling off a few cells but good offroad bashing packs or pratice packs. asking $40 shipped for all 3
Motors
- i have a reedy mod 10X1 only cut a few times dont have comm mesurements. asking $30 shipped
- C2 19t it was a hand out motor for nats. only run a few times and i think only 2 cuts on it. was used in 12th scale so it has not even been heated up, so thee wont be any fade in the mags. asking $20 shipped
or $45 shipped for both
i have a few after market parts i no longer use/need. both have only been used once.
- MIP shinny CVDs only used once absolutely brand new condition, no wear on them at all. asking $25 shipped
- Square purple aluminum rear hubs. one has a scratch on it but not to major but still in great condition asking $25 shipped
Batts
3x Fusion Team 3700s, AV 1.189-1.1886 IR 2.3
pro built. been sitting for a while but stored them fully charged so i think they need to by cycled once or twice. the shrink wrap if falling off a few cells but good offroad bashing packs or pratice packs. asking $40 shipped for all 3
Motors
- i have a reedy mod 10X1 only cut a few times dont have comm mesurements. asking $30 shipped
- C2 19t it was a hand out motor for nats. only run a few times and i think only 2 cuts on it. was used in 12th scale so it has not even been heated up, so thee wont be any fade in the mags. asking $20 shipped
or $45 shipped for both
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
