U.S. Vintage Trans-Am [PICS & PAINT Discussion ONLY!!!]
#4531
Thanks Been a lot of good info ! I like that cutter you would get a perfect circle
#4532
Tech Champion
iTrader: (2)
I like to put lights in my VTA shell and I use the circle cutter on the left over vinyl from the window masks that come with the shell. Circle cutter puts down some great circles for that. Plus I use it to get my wheel wells right.
Last edited by snoopyrc; 01-24-2014 at 11:11 PM.
#4533
I like my OLFA circle cutter
#4534
Technically not a T/A racer but too cool not to post. See the header coming out of the front wheel well! Those Mickey Thompson's are going to go fierce!
#4536
Tech Champion
iTrader: (2)
I wish HPI would just re tool the Gittin mold to represent the standard Mustang. I'm great with the spoiler and fenders and I think the side scoop is a little exaggerated but I'm good with that too. If the hood and headlights were fixed it would be perfect. That and a decal sheet more like the other Mustang.
Or Protoform could do it. I would love to see what the Epps would come up with.
Or Protoform could do it. I would love to see what the Epps would come up with.
#4540
Been working on this PROTOForm J71 this weekend for a Wisconsin racer. I had done a similar one recently in red. He contacted me to do one for him, but he wanted the fusion green look. That green is a sweet color! Numerals and spikes are hand cut using Fasmask and some lengthy layout time. Should look great on the track for him. That nose is just held in place with a little masking tape. Once it is glued, it will be a better fit.
#4542
#4544