mop_iko

i need clarification on the supplied rear wing support for MAZDA 6 body.


1) what kind of handling effect IF i didnt put them on?
2) what kind of effect IF i only put 1 screw only at point A and didnt put any glue or screw up until point B.
3) do i really need to put screw/glue up until point B?


thanks!

mop

KREATOR1

iTrader: (8)

I dont know its the body shell or my car setting , but
i drive better with the mazda6 body compare to stratus ( on the same car )

KREATOR1

iTrader: (8)

This is a picture of my painted body.Using tamiya spray can.

KREATOR1

iTrader: (8)

front view. Bad huh!!! im not good at it.
Sometimes cheap masking tape works , sometimes dont

KREATOR1

iTrader: (8)

one more

Wency_TA03R-PRO

Nice try bro!! At least you didn'y ruin your bodyshell unlike what I did to my stratus 2nd body.






KREATOR1

Nice decals bro!!! I think I saw a GT7 in that kit? Am I right?. What kit was that?.

KREATOR1

iTrader: (8)

Thanks, its not GT7, its a Novak TC2 cyclone

Wency_TA03R-PRO

Ah ok..

Wency_TA03R-PRO

Just want to ask a question are you using FM radio with your TC2 cyclone?. Is novak capable of handling AM band radio?.

KREATOR1

iTrader: (8)

im not sure about that. But im using M8 fm for my TC2.
you have too?

mop_iko

KREATOR1.... u have a nice colour scheme and also i like the way the flame dispearse effect towards the back of your car....also you put the flame on the roof....(which i always forget to put something on the roof!!!)...

but same problem as me... we need more patience in doing those masking and have a steady hand.... if we could have a more nice sexy curves and constant line... it would make the pattern more nicer....

now i challenge both of us..... our next post will show a better masking line..... when? i dont know... its up to you... and up to me.

good luck to your next body dude!

mop

KREATOR1

iTrader: (8)

Mop iko thank you thank you.

U right about being patience.when it comes to masking tape,
My patience went out shopping.Its hard to do sexy curves.
Should pratice more.When?? hehehhe when these 2 body
brake into 2.

acutts

All of you on this thread have inspired me to get an airbrush....! I have been looking through the posts and from what I can see the IWATA HP-C is the airbrush to have. ( I will be using Faskolor paints and will start with compressed air cans and then invest in a compressor)

Please advise if this is the right assumption or if there is something else I should be looking at. The cost of the brush is insignificant ... I want to get the best available cos in my opinion if you don't do that to start you end up buying twice and costing you more.

Opinions greatly appreciated.... Thanks

bSimpson

I've never used the Iwata, but I have been very happy with the paasche VLS- simple to use, simple to clean!

Benjamin

That is simply wicked. I love how you did the windows. UNIQUE.