Originally Posted by Nitro$junkie (Post 3292642)

http://www.redrc.net/wp-content/uplo...oolinghead.jpg

Active Hobby of Japan have announced that they will be selling this new cooling for both O.S. TZ12 and .12 Novarossi based engines. Its super lightweight, keeping the cars center of gravity low, and is deisgned in such a way as to improve the air flow and cooling around the engine head, while the colour coating is very efficient at dispersing heat. Available in matt red, matt blue (above) and gun metal grey.

Source: Active Hobby [active-hobby.com]

Originally Posted by SEBAS V (Post 3547667)

HI GUYS,

I RUN MY V ONE RRR AT 10.000 FT ABOVE SEA LEVEL, !!!!!!!!!
I HAVE A .12 TZ EB MODS WITH GREAT RESULTS SO FAR, JUST AFTER BREAK IN I TOOK THE 0.2 SHIM OUT AND PUT A P7 GLOW PLUG. I GET ALMOST 7 TO 8 MIN OF RUN TIME WHICH MAKES ME WONDER IF I COULD TAKE THE 0.1 SHIM OUT. SHOULD I DO THIS, IT IS SAFE FOR THE ENGINE HEAD TO BE INSTALLED WITHOUT SHIMS???

Originally Posted by rcabj (Post 3560511)

not so sure about u, but i am about 100-200 ft above sea level....i find my stock TZ is better with 0.4shims when using P7 plug and 16% nitro..runtime usually more or less 6 minutes.

BTW guys.... i found out my TZ3 + max 2602 pipe combo to be very impressive all round.

Originally Posted by SEBAS V (Post 3561211)

I will give it a try with the 0.4 shims, is safer for my engine. But i am still wondering if i could take all the shims out, would the piston hit the head?