R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Nitro On-Road > Onroad Nitro Engine Zone

Thread Tools Search this Thread
Old 10-07-2008, 10:41 PM   #1
Tech Adept
Join Date: Aug 2008
Posts: 177
Trader Rating: 8 (100%+)
Default Wear on sg shaft werks b7

I seem to have gotten alot of wear at the bearings at about 3 gals i've ran an STS & RB in same mbx5 with no signs wear . This engine has always ate up clutch bearings for no apperent reason but I've always changed them out before they went real bad. Has anyone cut off the shaft and used the nut with the shaft on it."don't know the name" These parts shafts seem real hard.
153stars is offline   Reply With Quote

Similar Threads
Thread Thread Starter Forum Replies Last Post
RCLAB 7even Cars. chrisman Electric On-Road 1443 03-21-2017 12:55 PM
Shaft or Belt for Drifting? Renuco612 Electric On-Road 14 12-23-2007 03:12 AM
What are the effects of a oneway on the center shaft FUK_WRX Nitro On-Road 8 12-16-2004 04:09 PM
belt vs shaft Quietroit Nitro On-Road 112 07-14-2004 02:40 PM
Question about SG shaft & threaded shaft on RS4 2/NTC3 ProRacer03 Nitro On-Road 3 12-13-2002 12:11 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

All times are GMT -7. It is currently 07:46 AM.

Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net