screws
 

anyone used the stainless steel screw kits from r/c screwz?
are they worht the trouble?

THey are ok , stainless strips easier though , stay with steel screws in high maintaince areas .

theyre pretty good, i ordered 2 sets so i have a back up screw for every spot, lol

are they lighter than steel?

Hi

the mugen titainium upper screw set is quite good also

;) Baz

not sure about the weight, fells a litle lighter but dont quote me on that.

spare parts
 

hi guys..usually what common parts u bring along during races...thanks:D

Re: spare parts
 

belts, tires, axle and drive shafts;) (thats for me dont know about the others):D :D

Spares should include front arms, steering knuckles, belts, pulleys, bearings and as much stuff your budget allows. It is better to be prepared than have to bum of other racers. And of coarse extra tires and glow plugs.

ONE-OF-A-KIND MRX-3 DECALS
 

Quick question:

Is your MTX3's rear end can touch the ground ? I mean the rear end chassis can hit the ground if you press down the car.

My MTX3's rear end cannot touch the ground, it has 5mm gap between them. Is this normal ?

BTW...... how long the 1/10 engine will last ? can you calculate by operating hours ?

My engine is JP FX 5 ports.

thats abnormal. are your foam tyres very low ? and are your shocks adjusted all the way down?

your JP FX i think would last around 10-12 litres if you change the con-rod every 3 litres i think.

Abnormal :confused: :confused: ?? OMG.... is it only me ?

The foam tires are brand new and un-shaved. My rear shock cannot fully compressed because something is limiting the downward travel. :confused: :confused:

Does your question answer itself? It's actually backwards, something is limiting the uptravel of the arms, Check your limit screws.